You can add a vanishing point to the ruler to match the shape of the fisheye.ġ. You can also enable snapping to the ruler or grid to help in your drawing. Mix fish eye eliminator, a specially designed paint additive, into your clear coat material before you begin painting. You can adjust the guide lines and vanishing point according to what you want to draw. The lower right controller lets you turn the snap function on and off. Two-component paints and varnishes are more sensitive than 1-component products when it comes to fisheyes. Do not use fisheye eliminator in undercoats or basecoat color. If fisheyes appear in a basecoat, allow the color to dry then spray a mist coat over affected area. The upper left controller changes the position of the controller to move the entire ruler. To avoid paint bubbles before painting, thoroughly clean the surface with detergent and hot water, followed by a solvent cleaner. The mix then must be applied in light coats. You can change the position and angel of the eye level (blue).Ĭhange the position of the eye level with the central controller and change the angle by moving the small controllers on the sides.Ī vanishing point snapped to above the eye level will also be moved if you move the eye level.Īs outlined in “Adjusting the fisheye distortion,” you can move the entire fisheye perspective ruler position. Add 10ml of 804 FISH EYE KILLER (approximately one cap) to 500ml (one gravity spray gun vase) of mixed paint. 4) Excess film build will aggravate the fisheye problem. 3) You dont need to thin it - cc is already a thin product. You cannot move the controller outside the lens circle.ĭrag the controller to change the center of the fisheye lens. Cabinet Coat is a urethane product and as such itll be sensitive to surface contaminants. The snap function can be switched on and off with the square controller on the lower right of the white circle. Fish eyes are where a coating pulls away from the underlying surface creating holes or craters in the topcoat. You can change the slope of the angle of the guide line by dragging the blue circles at both ends. Fish Eyes - Craters In Epoxy Paint Surfaces. Drag and move the middle white circle to move the guide lines.
0 Comments
Leave a Reply. |